JEE (Main + Adv) · Physics

Current Electricity

29 practice questions with full step-by-step solutions, quick revision notes — free, no sign-up.

Reviewed by (19 years teaching)Written with AI helpReport a mistake

This chapter has

7
easy
15
medium
7
hard

Current Electricity — quick revision notes

This chapter covers current, drift velocity and mobility, Ohm's law, resistivity and how it depends on temperature, series and parallel resistors, emf and internal resistance, combinations of cells, Kirchhoff's laws, the Wheatstone bridge and the metre bridge, and electrical power and energy. JEE Main usually sets 1–2 numericals on it, often on equivalent resistance, Kirchhoff networks, cell combinations or stretched wires.
  • I = neAv_d. Drift velocity v_d = eEτ/m, mobility μ = v_d/E = eτ/m, and J = I/A = σE.
  • R = ρl/A with ρ = m/(ne²τ). For a wire stretched at constant volume, R ∝ l² ∝ 1/r⁴. A frustum with end radii a and b has R = ρL/(πab).
  • Temperature: R = R₀(1 + αΔT). For metals α > 0 (τ falls as T rises). For semiconductors and carbon α < 0. For resistors in series, α_eff = ΣR_iα_i/ΣR_i.
  • Terminal voltage V = E − Ir when the cell discharges and V = E + Ir when it is charged. Power to the load is largest at R = r, giving P_max = E²/4r at 50% efficiency.
  • Cells in series: E_eq = ΣE (subtract 2E for each reversed cell) and r_eq = Σr. Cells in parallel: E_eq = (ΣE_i/r_i)/(Σ1/r_i) and 1/r_eq = Σ1/r_i.
  • Kirchhoff's laws: the junction rule (conservation of charge) and the loop rule ΣE = ΣIR. A negative answer means the actual current is opposite to the assumed direction.
  • Wheatstone balance: P/Q = R/S, and then the galvanometer arm can be removed. Metre bridge: X/R = l/(100 − l).
  • Power P = VI = I²R = V²/R. In series the higher-R bulb is brighter; in parallel the lower-R bulb is brighter. For a fixed heat, heater times add in series and combine like parallel resistors in parallel. Cube of resistors r: 7r/12 across an edge, 3r/4 across a face diagonal, 5r/6 across the body diagonal. Infinite R–R ladder: R(1 + √5)/2.

Common mistakes to avoid

  • Treating a stretched wire as R ∝ l instead of R ∝ l² (constant volume), or forgetting that drawing out the radius changes the length too.
  • Thinking that a reversed cell in a series string removes only its own emf. It cancels one more cell as well, so subtract 2E, while its internal resistance still adds.
  • Assuming a cell in a parallel combination always discharges. Find its actual current with Kirchhoff's laws; it may be charging or carry no current.
  • Forgetting that in the DC steady state a capacitor branch carries no current, and that a real voltmeter loads the circuit and reads less.
Exam tip: For any network, first look for symmetry or a balanced bridge to remove resistors, then apply the junction rule with one unknown node voltage instead of writing several loop equations. Check every answer with the power or current balance at a node.

Current Electricity — solved practice questions

7 JEE Physics questions with step-by-step solutions. Attempt each, then reveal the answer.

These worked examples are not in the timed test, so you can study them first.

  1. Q1easyReport

    A copper wire of cross-sectional area 1.0 mm² carries a steady current of 1.5 A. The free-electron density of copper is 8.5 × 10²⁸ m⁻³ (e = 1.6 × 10⁻¹⁹ C). The drift speed of the electrons is about:

    • A2.2 × 10⁻⁴ m/s
    • B1.1 × 10⁻⁵ m/s
    • C1.1 × 10⁻³ m/s
    • D1.1 × 10⁻⁴ m/s
    Show answer & solution

    Correct answer: (D) 1.1 × 10⁻⁴ m/s

    v_d = I/(neA) = 1.5/(8.5×10²⁸ × 1.6×10⁻¹⁹ × 10⁻⁶) = 1.5/(1.36×10⁴) ≈ 1.1 × 10⁻⁴ m/s.
  2. Q2easyReport

    A wire of resistance 5 Ω is stretched uniformly until its length doubles. Its volume does not change. Its new resistance is:

    • A10 Ω
    • B2.5 Ω
    • C40 Ω
    • D20 Ω
    Show answer & solution

    Correct answer: (D) 20 Ω

    At constant volume, A = V/l, so R = ρl²/V ∝ l². Doubling l makes R four times larger: 4 × 5 = 20 Ω.
  3. Q3mediumReport

    A wire of resistance R is drawn out (volume constant) until its radius is half the original. Its new resistance is:

    • A4R
    • B8R
    • C16R
    • D2R
    Show answer & solution

    Correct answer: (C) 16R

    Halving r makes A one quarter, so at constant volume l becomes 4 times. R = ρl/A therefore grows by 4 × 4 = 16, giving 16R (equivalently R ∝ 1/r⁴).
  4. Q4easyReport

    A resistor has resistance 10 Ω at 20 °C, and its temperature coefficient of resistance (referred to 20 °C) is 4.0 × 10⁻³ °C⁻¹. Its resistance at 70 °C is:

    • A10.4 Ω
    • B12 Ω
    • C11.2 Ω
    • D14 Ω
    Show answer & solution

    Correct answer: (B) 12 Ω

    R = R₀(1 + αΔT) = 10(1 + 4×10⁻³ × 50) = 10 × 1.2 = 12 Ω.
  5. Q5mediumReport

    For copper, resistivity ρ = 1.7 × 10⁻⁸ Ω m and free-electron density n = 8.5 × 10²⁸ m⁻³. Take mₑ = 9.1 × 10⁻³¹ kg and e = 1.6 × 10⁻¹⁹ C. The relaxation time of the electrons is about:

    • A2.5 × 10⁻¹⁶ s
    • B2.5 × 10⁻¹⁴ s
    • C2.5 × 10⁻¹² s
    • D4.0 × 10⁻¹⁴ s
    Show answer & solution

    Correct answer: (B) 2.5 × 10⁻¹⁴ s

    ρ = m/(ne²τ), so τ = m/(ne²ρ) = 9.1×10⁻³¹/(8.5×10²⁸ × 2.56×10⁻³⁸ × 1.7×10⁻⁸) = 9.1×10⁻³¹/3.70×10⁻¹⁷ ≈ 2.5 × 10⁻¹⁴ s.
  6. Q6easyReport

    A 3 Ω resistor and a 6 Ω resistor are joined in parallel. This combination is in series with a 4 Ω resistor across an ideal 12 V battery. The current through the 6 Ω resistor is:

    • A4/3 A
    • B2 A
    • C1 A
    • D2/3 A
    Show answer & solution

    Correct answer: (D) 2/3 A

    3 ∥ 6 = 2 Ω, so the total is 6 Ω and I = 2 A. The voltage across the parallel part is 2 × 2 = 4 V, so the 6 Ω resistor carries 4/6 = 2/3 A.
  7. Q7easyReport

    A cell of emf 2.0 V and internal resistance 0.5 Ω is connected to an external resistor of 3.5 Ω. The potential difference across the terminals of the cell is:

    • A2.0 V
    • B1.75 V
    • C1.5 V
    • D0.25 V
    Show answer & solution

    Correct answer: (B) 1.75 V

    I = E/(R + r) = 2/4 = 0.5 A. Terminal voltage V = E − Ir = 2 − 0.25 = 1.75 V (check: IR = 0.5 × 3.5 = 1.75 V).

Ready to test yourself? Take the 22-question Current Electricity test →