JEE (Main + Adv) · Physics

Alternating Current

30 practice questions with full step-by-step solutions, quick revision notes — free, no sign-up.

Reviewed by (19 years teaching)Written with AI helpReport a mistake

This chapter has

8
easy
15
medium
7
hard

Alternating Current — quick revision notes

This chapter covers rms and average values, the behaviour of R, L and C in AC circuits, phasors, series LCR impedance, resonance and the Q-factor, power and power factor, LC oscillations and transformers. JEE Main asks mostly short numericals on impedance, phase, power, resonance and rms values, plus LC energy-sharing and transformer questions.
  • V_rms = V₀/√2 and I_rms = I₀/√2 for a sine wave. Half-cycle average = 2I₀/π, full-cycle average = 0. Half-wave rectified: rms = I₀/2, average = I₀/π.
  • X_L = ωL and X_C = 1/(ωC). Series LCR: Z = √(R² + (X_L − X_C)²) and tan φ = (X_L − X_C)/R. In L the current lags V by 90°; in C it leads by 90°.
  • Average power P = V_rms I_rms cos φ = I_rms²R, with power factor cos φ = R/Z. Wattless current = I_rms sin φ. Pure L or C: P = 0.
  • Resonance: ω₀ = 1/√(LC), Z = R (minimum), current is maximum and the power factor is 1. V_L = V_C = Q·V.
  • Q = ω₀L/R = (1/R)√(L/C) = ω₀/Δω. Half-power bandwidth Δω = R/L.
  • LC oscillation: ω = 1/√(LC), q = Q₀ cos ωt, I₀ = ωQ₀. Energy is shared equally at q = Q₀/√2, first at t = T/8.
  • Ideal transformer: V_s/V_p = N_s/N_p = I_p/I_s, so power is conserved. Efficiency η = P_out/P_in. Losses come from copper (I²R), eddy currents, hysteresis and flux leakage.
  • For mixed currents such as i = a + b sin ωt: I_rms = √(a² + b²/2).

Common mistakes to avoid

  • Adding V_R, V_L and V_C arithmetically instead of as phasors: V = √(V_R² + (V_L − V_C)²).
  • Using the peak current in P = I²R when the rms value is needed (P = ½I₀²R with peak values).
  • Treating X_L as frequency-independent when the frequency changes: X_L ∝ f and X_C ∝ 1/f.
  • Confusing lead and lag: the current leads in a capacitive circuit and lags in an inductive one.
Exam tip: For any series LCR numerical, first write X_L, X_C, Z and cos φ in one line; almost every quantity follows from these four. Quickly check that the resonance and Q values are consistent with one another.

Alternating Current — solved practice questions

8 JEE Physics questions with step-by-step solutions. Attempt each, then reveal the answer.

These worked examples are not in the timed test, so you can study them first.

  1. Q1easyReport

    An AC voltage is given by V = 220√2 sin(100πt) volt. What is its rms value?

    • A110√2 V
    • B220 V
    • C110 V
    • D220√2 V
    Show answer & solution

    Correct answer: (B) 220 V

    Peak V₀ = 220√2 V, and V_rms = V₀/√2 = 220 V.
  2. Q2easyReport

    A sinusoidal current has peak value I₀. What is its average value over one half cycle?

    • A2I₀/π
    • BI₀/√2
    • CI₀/π
    • DZero
    Show answer & solution

    Correct answer: (A) 2I₀/π

    Over a half cycle, I_avg = (1/π)∫₀π I₀ sin θ dθ = 2I₀/π ≈ 0.637 I₀. The average over a full cycle is zero.
  3. Q3easyReport

    What is the reactance of a pure inductor of 0.5 H connected to a 50 Hz AC supply?

    • A25 Ω
    • B50 Ω
    • C100π Ω
    • D50π Ω
    Show answer & solution

    Correct answer: (D) 50π Ω

    X_L = 2πfL = 2π × 50 × 0.5 = 50π Ω ≈ 157 Ω.
  4. Q4easyReport

    A capacitor of capacitance (100/π) μF is connected to a 50 Hz AC source. What is its capacitive reactance?

    • A200 Ω
    • B50 Ω
    • C100 Ω
    • D100π Ω
    Show answer & solution

    Correct answer: (C) 100 Ω

    X_C = 1/(2πfC) = 1/(2π × 50 × (100/π) × 10⁻⁶) = 1/(10⁻²) = 100 Ω.
  5. Q5mediumReport

    A series LCR circuit has R = 30 Ω, X_L = 80 Ω and X_C = 40 Ω. It is connected to a 200 V (rms) AC supply. What is the average power dissipated?

    • A800 W
    • B960 W
    • C480 W
    • D640 W
    Show answer & solution

    Correct answer: (C) 480 W

    Z = √(30² + 40²) = 50 Ω, so I_rms = 200/50 = 4 A. P = I²R = 16 × 30 = 480 W. Check: V I cos φ = 200 × 4 × 0.6 = 480 W.
  6. Q6mediumReport

    What is the resonant angular frequency of a series LCR circuit with L = 2 mH and C = 5 μF?

    • A10⁵ rad/s
    • B10⁴ rad/s
    • C2π × 10⁴ rad/s
    • D10³ rad/s
    Show answer & solution

    Correct answer: (B) 10⁴ rad/s

    ω₀ = 1/√(LC) = 1/√(2×10⁻³ × 5×10⁻⁶) = 1/√(10⁻⁸) = 10⁴ rad/s.
  7. Q7mediumReport

    A series LCR circuit has R = 10 Ω, L = 0.1 H and C = 10 μF. What is its quality factor (Q-factor)?

    • A10
    • B100
    • C1
    • D0.1
    Show answer & solution

    Correct answer: (A) 10

    ω₀ = 1/√(0.1 × 10⁻⁵) = 1000 rad/s, so Q = ω₀L/R = 100/10 = 10. Check: (1/R)√(L/C) = (1/10)√(10⁴) = 10.
  8. Q8mediumReport

    A series LCR circuit with R = 10 Ω, L = 0.1 H and C = 10 μF is connected to a 100 V (rms) source tuned to resonance. What is the rms voltage across the inductor?

    • A10000 V
    • B1000 V
    • C10 V
    • D100 V
    Show answer & solution

    Correct answer: (B) 1000 V

    At resonance I = V/R = 10 A and X_L = ω₀L = 1000 × 0.1 = 100 Ω, so V_L = 10 × 100 = 1000 V. This equals Q × V = 10 × 100 V.

Ready to test yourself? Take the 22-question Alternating Current test →