NEET (Medical) · Physics

Current Electricity

30 practice questions with full step-by-step solutions, quick revision notes — free, no sign-up.

Reviewed by (19 years teaching)Written with AI helpReport a mistake

This chapter has

10
easy
14
medium
6
hard

Current Electricity — quick revision notes

The chapter covers drift of charges and current, Ohm's law, resistivity and its temperature dependence, emf and internal resistance, combining cells, Kirchhoff's rules, and the Wheatstone and metre bridge, all following the current NCERT; potentiometer and colour code are not in the NEET 2026 syllabus. NEET usually sets 2–3 questions: short numericals on drift speed, stretched wires, cell combinations, power and bridge balance, plus one conceptual or statement-based item.
  • I = neAv_d; v_d = eEτ/m = μE; mobility μ = eτ/m in m² V⁻¹ s⁻¹; j = σE = I/A
  • ρ = m/(ne²τ); R = ρL/A. When a wire is stretched n times at constant volume, R becomes n²R
  • R_t = R₀(1 + αΔT). Metals have α > 0; semiconductors have α < 0; manganin and constantan have very small α (standard resistors); nichrome is used for heaters
  • Terminal voltage V = E − Ir when the cell is discharging. Maximum power E²/4r is delivered when R = r. Equal power in R₁ and R₂ means r = √(R₁R₂)
  • Cells in series: E_eq = ΣE (a reversed cell subtracts 2E) and r_eq = Σr. In parallel: E_eq = (ΣE/r)/(Σ1/r) and 1/r_eq = Σ1/r
  • Kirchhoff: the junction rule comes from conservation of charge and the loop rule from conservation of energy
  • Balanced Wheatstone bridge: P/Q = R/S, and the galvanometer arm carries no current, so it can be ignored. Metre bridge: X/R = l/(100 − l)
  • P = VI = I²R = V²/R; R_bulb = V_rated²/P_rated; 1 kWh = 3.6 × 10⁶ J

Common mistakes to avoid

  • Stretching at constant volume multiplies R by n², not n
  • In series the lower-wattage bulb (higher R) glows brighter; in parallel the higher-wattage bulb is brighter
  • Increasing length at a fixed V reduces E and therefore v_d. Changing the area at fixed V leaves v_d unchanged
  • Do not add emfs directly for parallel cells; use the weighted formula
Exam tip: In circuit numericals, first look for symmetry or a balanced bridge, then use node analysis or Thevenin to cross-check. Check drift and resistivity answers against the exponent (v_d is about 10⁻⁴ m/s).

Current Electricity — solved practice questions

8 NEET Physics questions with step-by-step solutions. Attempt each, then reveal the answer.

These worked examples are not in the timed test, so you can study them first.

  1. Q1mediumReport

    A copper wire of cross-sectional area 1.0 mm² carries a current of 1.6 A. If the free-electron density in copper is 8.0 × 1028 m⁻³ (e = 1.6 × 10⁻¹⁹ C), the drift speed of the electrons is:

    • A2.5 × 10⁻⁴ m/s
    • B1.25 × 10⁻⁵ m/s
    • C1.25 × 10⁻⁴ m/s
    • D1.25 × 10⁻³ m/s
    Show answer & solution

    Correct answer: (C) 1.25 × 10⁻⁴ m/s

    v_d = I/(neA) = 1.6/(8.0×1028 × 1.6×10⁻¹⁹ × 1.0×10⁻⁶) = 1.6/(1.28×10⁴) = 1.25×10⁻⁴ m/s.
  2. Q2easyReport

    A wire of resistance 10 Ω is uniformly stretched to twice its original length, with its volume unchanged. Its new resistance is:

    • A40 Ω
    • B80 Ω
    • C20 Ω
    • D10 Ω
    Show answer & solution

    Correct answer: (A) 40 Ω

    When volume is constant, length doubles and area halves, so R = ρL/A becomes 2 × 2 = 4 times larger: 4 × 10 = 40 Ω.
  3. Q3easyReport

    The resistivity of a metallic conductor depends on:

    • Aits length only
    • Bthe nature of the material and its temperature
    • Cits area of cross-section only
    • Dits length and area of cross-section
    Show answer & solution

    Correct answer: (B) the nature of the material and its temperature

    Resistivity is a property of the material (ρ = m/ne²τ). It changes with temperature but does not depend on the conductor's dimensions.
  4. Q4hardReport

    A coil has a resistance of 5 Ω at 50 °C and 6 Ω at 100 °C. Assuming R = R₀(1 + αt), its resistance at 0 °C is:

    • A4 Ω
    • B3.5 Ω
    • C4.8 Ω
    • D4.5 Ω
    Show answer & solution

    Correct answer: (A) 4 Ω

    6/5 = (1 + 100α)/(1 + 50α) gives α = 0.005 °C⁻¹. Then R₀ = 5/(1 + 0.25) = 4 Ω. Check: 4(1 + 0.5) = 6 Ω.
  5. Q5easyReport

    The SI unit of electron mobility is:

    • Am² V s⁻¹
    • Bm V⁻¹ s⁻¹
    • Cm² V⁻¹ s⁻¹
    • DV m⁻¹ s⁻¹
    Show answer & solution

    Correct answer: (C) m² V⁻¹ s⁻¹

    Mobility μ = v_d/E = (m s⁻¹)/(V m⁻¹), so its unit is m² V⁻¹ s⁻¹.
  6. Q6mediumReport

    A cell of emf 12 V and internal resistance 1 Ω is connected across an external resistance of 5 Ω. The potential difference across the terminals of the cell is:

    • A12 V
    • B8 V
    • C2 V
    • D10 V
    Show answer & solution

    Correct answer: (D) 10 V

    I = E/(R + r) = 12/6 = 2 A, so V = E − Ir = 12 − 2 × 1 = 10 V. As a check, IR = 2 × 5 = 10 V.
  7. Q7mediumReport

    Ten identical cells, each of emf E and internal resistance r, are meant to be joined in series, but 2 of them are connected the wrong way round. The effective emf of the combination is:

    • A4E
    • B6E
    • C10E
    • D8E
    Show answer & solution

    Correct answer: (B) 6E

    Each reversed cell cancels the emf of one correct cell, so the net emf is (10 − 2×2)E = 6E. The internal resistance is still 10r.
  8. Q8hardReport

    Two cells, of emf 6 V and 4 V and each with internal resistance 1 Ω, are connected in parallel with their positive terminals joined together. The equivalent emf and equivalent internal resistance of the combination are:

    • A5 V, 2 Ω
    • B5 V, 0.5 Ω
    • C10 V, 2 Ω
    • D2 V, 0.5 Ω
    Show answer & solution

    Correct answer: (B) 5 V, 0.5 Ω

    E_eq = (E₁/r₁ + E₂/r₂)/(1/r₁ + 1/r₂) = (6 + 4)/2 = 5 V, and r_eq = r₁r₂/(r₁ + r₂) = 0.5 Ω.

Ready to test yourself? Take the 22-question Current Electricity test →