NEET (Medical) · Chemistry

Solutions

30 practice questions with full step-by-step solutions, quick revision notes — free, no sign-up.

Reviewed by (19 years teaching)Written with AI helpReport a mistake

This chapter has

10
easy
14
medium
6
hard

Solutions — quick revision notes

Covers the ways of expressing concentration, solubility of solids and gases (Henry's law), vapour pressure and Raoult's law, ideal and non-ideal solutions and azeotropes, the four colligative properties, and abnormal molar masses through the van't Hoff factor. NEET usually asks 2-3 questions from here: colligative-property and concentration numericals, plus conceptual questions on deviations, azeotropes, Henry's law and the value of i.
  • Molarity M = mol solute / L solution (changes with temperature); molality m = mol solute / kg solvent (does not change with temperature); M = 10 × d × (w%) / molar mass; ppm = (mass of solute/mass of solution) × 106.
  • Henry's law: p = KH x x. A higher KH means lower solubility; KH rises with temperature, so gases are less soluble in warm water. This explains bends (N2) and anoxia at high altitude.
  • Raoult's law: pA = p°A xA; total P = p°B + (p°A − p°B)xA; vapour mole fraction yA = pA/P (the vapour is richer in the more volatile component).
  • Ideal solution: ΔmixH = 0, ΔmixV = 0, ΔmixS > 0, ΔmixG < 0 (e.g. n-hexane/n-heptane, benzene/toluene). Positive deviation (ethanol-water, ethanol-acetone, CS2-acetone) gives a minimum boiling azeotrope; negative deviation (chloroform-acetone, HNO3-water at about 68%) gives a maximum boiling azeotrope.
  • Relative lowering of vapour pressure: (p° − p)/p° = x(solute) ≈ (w2 × M1)/(M2 × w1).
  • ΔTb = i x Kb x m; ΔTf = i x Kf x m; π = i x CRT. Molar mass M2 = (K × w2 × 1000)/(ΔT × w1 in g) or M2 = w2RT/(πV). Osmotic pressure is preferred for proteins and polymers.
  • van't Hoff factor i = normal molar mass / observed molar mass. For dissociation into n ions, i = 1 + α(n − 1); for association into n-mers, i = 1 − α(1 − 1/n) (dimer: 1 − α/2).
  • 0.9% (mass/volume) NaCl is isotonic with blood: cells swell in hypotonic and shrink in hypertonic solutions. Reverse osmosis (pressure greater than π, cellulose acetate membrane) is used to desalinate sea water.

Common mistakes to avoid

  • Dividing by the mass of the solution, or forgetting to convert grams to kilograms, when calculating molality.
  • Leaving out the van't Hoff factor for electrolytes, or assuming complete dissociation when α is given.
  • Confusing which deviation gives which azeotrope: positive deviation gives minimum boiling, negative gives maximum boiling.
  • Assuming a larger KH means higher solubility; it means lower solubility.
Exam tip: For any colligative-property question, first find the effective particle concentration (i × m or i × C), then pick the formula. Comparing boiling or freezing points of several solutions only needs the i × m values.

Solutions — solved practice questions

8 NEET Chemistry questions with step-by-step solutions. Attempt each, then reveal the answer.

These worked examples are not in the timed test, so you can study them first.

  1. Q1easyReport

    4 g of NaOH (molar mass 40 g/mol) is dissolved in 500 g of water. What is the molality of the solution?

    • A0.1 mol/kg
    • B0.02 mol/kg
    • C0.2 mol/kg
    • D0.4 mol/kg
    Show answer & solution

    Correct answer: (C) 0.2 mol/kg

    n = 4/40 = 0.1 mol; molality = 0.1 mol / 0.500 kg = 0.2 mol/kg.
  2. Q2easyReport

    Which of the following concentration terms does NOT change with temperature?

    • AMolality
    • BMolarity
    • CFormality
    • DNormality
    Show answer & solution

    Correct answer: (A) Molality

    Molality uses the mass of solvent, and mass does not change with temperature. Molarity, normality and formality all use the solution volume, which expands on heating.
  3. Q3mediumReport

    A solution contains 46 g of ethanol (molar mass 46 g/mol) and 36 g of water (molar mass 18 g/mol). What is the mole fraction of ethanol?

    • A0.333
    • B0.50
    • C0.667
    • D0.25
    Show answer & solution

    Correct answer: (A) 0.333

    n(ethanol) = 46/46 = 1 mol and n(water) = 36/18 = 2 mol, so x(ethanol) = 1/(1 + 2) = 0.333.
  4. Q4mediumReport

    Commercial sulphuric acid is 98% H2SO4 by mass and has a density of 1.84 g/mL (molar mass of H2SO4 = 98 g/mol). What is its molarity?

    • A9.2 M
    • B1.84 M
    • C36.8 M
    • D18.4 M
    Show answer & solution

    Correct answer: (D) 18.4 M

    1 L of acid weighs 1840 g, of which H2SO4 = 0.98 × 1840 = 1803.2 g = 18.4 mol, so the acid is 18.4 M. Check with the formula: M = 10 × d × w% / molar mass = 10 × 1.84 × 98 / 98 = 18.4 M.
  5. Q5mediumReport

    The Henry's law constant (KH) of N2 in water at 293 K is 76.48 kbar. What is the mole fraction of N2 dissolved in water when N2 is at a partial pressure of 1.0 bar?

    • A7.65 × 104
    • B1.31 × 10−2
    • C7.65 × 10−4
    • D1.31 × 10−5
    Show answer & solution

    Correct answer: (D) 1.31 × 10−5

    Henry's law gives x = p/KH = 1.0 bar / 76480 bar = 1.31 × 10−5.
  6. Q6easyReport

    At a given temperature, gas X has a higher Henry's law constant (KH) in water than gas Y. This means that gas X:

    • Ais more soluble in water than Y
    • Bis less soluble in water than Y
    • Chas a solubility that does not depend on pressure
    • Dmust be more polar than Y
    Show answer & solution

    Correct answer: (B) is less soluble in water than Y

    Since x = p/KH, a larger KH gives a smaller mole fraction at the same partial pressure, so the gas is less soluble.
  7. Q7easyReport

    Scuba divers who come up from deep water too quickly suffer from 'bends'. What causes it?

    • ALow solubility of O2 in blood at great depth
    • BHelium in the tank dissolving in blood and blocking nerve impulses
    • CMore N2 dissolves in blood at high pressure and comes out as bubbles when the pressure falls quickly
    • DCarbon monoxide poisoning from the air tank
    Show answer & solution

    Correct answer: (C) More N2 dissolves in blood at high pressure and comes out as bubbles when the pressure falls quickly

    Under high pressure more N2 dissolves in blood (Henry's law). On rapid ascent the pressure drops, the N2 forms bubbles in the capillaries and causes bends. Tanks use air diluted with helium to reduce this.
  8. Q8mediumReport

    Liquids A and B form an ideal solution. At a certain temperature the vapour pressures of pure A and pure B are 100 mm Hg and 40 mm Hg. For a solution in which the mole fraction of A is 0.4, what is the mole fraction of A in the vapour phase?

    • A0.400
    • B0.375
    • C0.600
    • D0.625
    Show answer & solution

    Correct answer: (D) 0.625

    pA = 0.4 × 100 = 40 mm Hg and pB = 0.6 × 40 = 24 mm Hg, so P = 64 mm Hg. Then yA = pA/P = 40/64 = 0.625.

Ready to test yourself? Take the 22-question Solutions test →