JEE (Main + Adv) · Physics
Wave Optics
29 practice questions with full step-by-step solutions, quick revision notes — free, no sign-up.
Reviewed by Kaustav Basak (19 years teaching)Written with AI helpReport a mistake
This chapter has
Wave Optics — quick revision notes
- YDSE: path difference Δ = yd/D. Bright fringes at y = nλD/d, dark fringes at (2n − 1)λD/2d. Fringe width β = λD/d; angular fringe width = λ/d
- In a medium of index μ, λ → λ/μ, so β and the angular width divide by μ. A thin film (μ, t) over one slit shifts the whole pattern by (μ − 1)tD/d towards the covered slit, and the number of fringes shifted is (μ − 1)t/λ
- Intensity: I = I₁ + I₂ + 2√(I₁I₂)cos φ, with φ = (2π/λ)Δ. For equal slits, I = 4I₀cos²(φ/2). I_max/I_min = (√I₁ + √I₂)²/(√I₁ − √I₂)²
- Coincident bright fringes of two wavelengths: n₁λ₁ = n₂λ₂ (use the smallest integers). With white light the central fringe is white. The fringe closest to it on either side is red and the farther ones are bluish (blue is removed first), and after a few fringes the pattern merges into uniform illumination
- Single slit: minima at a sin θ = nλ; secondary maxima approximately at a sin θ = (n + ½)λ. Central maximum: angular width 2λ/a, linear width 2λD/a (twice the width of the other maxima)
- Malus's law: I = I₀cos²θ. Unpolarised light through one polaroid gives I₀/2. Crossed pair with a middle sheet at θ gives (I₀/8)sin² 2θ
- Brewster's law: tan θ_B = μ, θ_B + r = 90°. Reflected light is fully polarised perpendicular to the plane of incidence. tan θ_B = 1/sin C
- Huygens: sin i/sin r = v₁/v₂ = μ₂/μ₁. Frequency is unchanged on refraction; speed and wavelength change
Common mistakes to avoid
- Placing the nth dark fringe at nβ instead of (n − ½)β
- Adding intensities instead of amplitudes when finding I_max/I_min, or forgetting that closing one slit leaves I/4 (not I/2) at the central maximum
- Using a sin θ = λ/2 for the first single-slit minimum (that is the double-slit condition), or giving the central-maximum width as λD/a instead of 2λD/a
- In a Brewster's-law sun-elevation problem, answering θ_B (measured from the vertical) instead of 90° − θ_B (the elevation above the horizon)
Wave Optics — solved practice questions
7 JEE Physics questions with step-by-step solutions. Attempt each, then reveal the answer.
These worked examples are not in the timed test, so you can study them first.
- Q1easyReport
In Young's double-slit experiment, λ = 600 nm, the slit separation is 0.5 mm and the screen is 1 m away. The fringe width is:
- A0.12 mm
- B1.2 mm
- C2.4 mm
- D0.6 mm
Show answer & solution
Correct answer: (B) 1.2 mm
β = λD/d = (600 × 10⁻⁹ × 1)/(0.5 × 10⁻³) = 1.2 × 10⁻³ m = 1.2 mm. - Q2easyReport
The YDSE arrangement of the previous setup, which gives a fringe width of 1.2 mm in air, is immersed completely in water (μ = 4/3). The new fringe width is:
- A1.6 mm
- B0.675 mm
- C1.2 mm
- D0.9 mm
Show answer & solution
Correct answer: (D) 0.9 mm
The wavelength in water is λ/μ, so β' = β/μ = 1.2 × 3/4 = 0.9 mm. - Q3mediumReport
In YDSE with λ = 500 nm, d = 1 mm and D = 2 m, the distance of the third dark fringe from the central maximum is:
- A1.5 mm
- B3 mm
- C3.5 mm
- D2.5 mm
Show answer & solution
Correct answer: (D) 2.5 mm
β = λD/d = 1 mm. The nth dark fringe is at (2n − 1)β/2, so the third is at 2.5β = 2.5 mm. - Q4mediumReport
In YDSE with λ = 600 nm, a thin transparent sheet of refractive index 1.5 placed over one slit shifts the central maximum by 5 fringe widths. The thickness of the sheet is:
- A3 μm
- B6 μm
- C12 μm
- D1.5 μm
Show answer & solution
Correct answer: (B) 6 μm
The extra optical path is (μ − 1)t = nλ, so t = 5 × 600 nm/0.5 = 6000 nm = 6 μm. The fringes shift towards the covered slit. - Q5mediumReport
The intensities of light from the two slits in a YDSE are in the ratio 9 : 1. The ratio of maximum to minimum intensity in the interference pattern is:
- A3 : 1
- B9 : 1
- C16 : 1
- D4 : 1
Show answer & solution
Correct answer: (D) 4 : 1
The amplitude ratio is √9 : √1 = 3 : 1. I_max/I_min = (3 + 1)²/(3 − 1)² = 16/4 = 4. - Q6mediumReport
In YDSE with identical slits, the intensity at a point on the screen where the path difference is λ/6, as a fraction of the maximum intensity, is:
- A√3/2
- B3/4
- C1/4
- D1/2
Show answer & solution
Correct answer: (B) 3/4
Phase difference φ = (2π/λ)(λ/6) = π/3. I = I_max cos²(φ/2) = I_max cos²(π/6) = (3/4)I_max. - Q7hardReport
A double-slit experiment uses light containing two wavelengths, 650 nm and 520 nm, with d = 0.5 mm and D = 1 m. The least distance from the central maximum at which bright fringes of both wavelengths coincide is:
- A1.3 mm
- B2.6 mm
- C5.2 mm
- D10.4 mm
Show answer & solution
Correct answer: (C) 5.2 mm
Coincidence requires n₁(650) = n₂(520), so n₁/n₂ = 4/5 and the smallest case is n₁ = 4. y = 4 × 650 × 10⁻⁹ × 1/(0.5 × 10⁻³) = 5.2 mm. Check: 5 × 1.04 mm = 5.2 mm.
Ready to test yourself? Take the 22-question Wave Optics test →