CUET UG · Physics

Magnetic Effects of Current, Magnetism, EMI and Alternating Current

25 practice questions with full step-by-step solutions, quick revision notes — free, no sign-up.

Reviewed by (19 years teaching)Written with AI helpReport a mistake

This chapter has

9
easy
13
medium
3
hard

Magnetic Effects of Current, Magnetism, EMI and Alternating Current — quick revision notes

Unit 3 covers the magnetic effects of current: Biot-Savart and Ampere's laws, the Lorentz force, forces and torques on currents, the moving coil galvanometer, bar magnets and magnetic materials. Unit 4 covers Faraday's and Lenz's laws, self and mutual inductance, AC quantities (rms values, reactance, impedance, resonance, power factor), the AC generator and the transformer. CUET mixes direct formula use with statement and matching questions about principles.
  • Field at the centre of a circular loop is B = mu0 I / 2R. For a long straight wire, B = mu0 I / 2 pi r. Inside a long solenoid, B = mu0 n I.
  • Lorentz force F = q(E + v × B). The magnetic force is zero when v is parallel to B, and it never changes the particle's speed.
  • Two parallel wires attract if the currents are in the same direction and repel if opposite. The ampere was defined using a force of 2 × 10−7 N per metre for wires 1 m apart in vacuum.
  • Galvanometer to ammeter: a small shunt in parallel, S = Ig G / (I - Ig). Galvanometer to voltmeter: a high resistance in series, R = V/Ig - G.
  • Short bar magnet: the axial field is parallel to m and twice the equatorial field. The equatorial field is antiparallel to m.
  • Self-induced emf e = -L dI/dt. Mutual inductance depends on geometry, separation, orientation and the core material, not on the current.
  • AC: Irms = I0/√2. XL = omega L. XC = 1/(omega C). Z = √(R2 + (XL - XC)2). Average power P = Vrms Irms cos(phi).
  • At resonance XL = XC and Z = R, and the current is maximum. VL and VC can each be much larger than the source voltage.
  • AC generator: peak emf e0 = NBA omega. A transformer works on mutual induction, does not work on steady DC, and in an ideal step-up transformer the secondary current is smaller than the primary current.

Common mistakes to avoid

  • Connecting the shunt in series or the voltmeter resistance in parallel. Shunt goes in parallel (ammeter); series resistance makes a voltmeter.
  • Thinking a transformer can step up DC. A steady current gives no changing flux, so no emf is induced.
  • Assuming the voltage across L or C in a series LCR circuit can never exceed the supply voltage. At resonance it can be Q times larger.
  • Adding the fields of concentric loops with opposite currents instead of subtracting them.
Exam tip: For Lenz's law questions, first decide whether the flux is increasing or decreasing, then choose the induced current that opposes that change. For AC numericals, find Z first and then work out the current, voltages and power.

Magnetic Effects of Current, Magnetism, EMI and Alternating Current — solved practice questions

6 CUET UG Physics questions with step-by-step solutions. Attempt each, then reveal the answer.

These worked examples are not in the timed test, so you can study them first.

  1. Q1easyReport

    Oersted's experiment, in which a compass needle placed near a wire is deflected when current flows through the wire, showed that

    • Aa magnetic field produces an electric current in a wire
    • Ba compass needle carries an electric charge
    • Ca current-carrying wire becomes electrically charged
    • Dan electric current produces a magnetic field around it
    Show answer & solution

    Correct answer: (D) an electric current produces a magnetic field around it

    Oersted found in 1820 that a current in a wire deflects a nearby compass needle. This showed that moving charges (currents) produce magnetic fields, the first link found between electricity and magnetism.
  2. Q2easyReport

    In the definition of the ampere based on the force between two parallel conductors (as given in NCERT), two infinitely long straight parallel wires 1 m apart in vacuum, each carrying 1 A, experience a force per unit length of

    • A1 N/m
    • B4 pi × 10−7 N/m
    • C2 × 10−7 N/m
    • D1 × 10−7 N/m
    Show answer & solution

    Correct answer: (C) 2 × 10−7 N/m

    The force per unit length is F/L = mu0 I1 I2/(2 pi d) = (4 pi × 10−7 × 1 × 1)/(2 pi × 1) = 2 × 10−7 N/m. The ampere was defined as the current that produces exactly this force.
  3. Q3mediumReport

    A galvanometer of resistance 50 ohm gives full-scale deflection for a current of 2 mA. To convert it into a voltmeter of range 0 to 10 V, you should connect

    • Aa resistance of 4950 ohm in series
    • Ba resistance of 5000 ohm in series
    • Ca resistance of 4950 ohm in parallel
    • Da resistance of 0.01 ohm in parallel
    Show answer & solution

    Correct answer: (A) a resistance of 4950 ohm in series

    A voltmeter needs a high resistance in series. R = V/Ig - G = 10/(2 × 10−3) - 50 = 5000 - 50 = 4950 ohm, connected in series.
  4. Q4mediumReport

    A galvanometer of resistance 99 ohm gives full-scale deflection for 10 mA. What shunt resistance is needed to convert it into an ammeter of range 0 to 1 A?

    • A9.9 ohm
    • B1 ohm
    • C0.99 ohm
    • D0.1 ohm
    Show answer & solution

    Correct answer: (B) 1 ohm

    The shunt carries I - Ig = 1 - 0.01 = 0.99 A, and it has the same potential difference across it as the galvanometer. So S = Ig G/(I - Ig) = (0.01 × 99)/0.99 = 1 ohm, connected in parallel.
  5. Q5mediumReport

    A positively charged particle is projected into a region with a uniform electric field E and a uniform magnetic field B, both parallel to its initial velocity. Neglecting gravity, the particle will

    • Amove along a straight line with constant speed
    • Bmove in a helix with increasing pitch
    • Cmove in a circle with constant speed
    • Dmove along a straight line with its speed changing
    Show answer & solution

    Correct answer: (D) move along a straight line with its speed changing

    Because v is parallel to B, the magnetic force q(v × B) is zero. The electric force qE acts along the line of motion, so the particle stays on a straight line while its speed increases.
  6. Q6mediumReport

    Match List-I (physical quantity) with List-II (SI unit). List-I: A. Magnetic dipole moment; B. Magnetic field; C. Current sensitivity of a galvanometer; D. Magnetization. List-II: I. tesla; II. ampere per metre (A/m); III. ampere square metre (A m2); IV. radian per ampere (rad/A). Choose the correct answer from the options given below.

    • AA-I, B-III, C-IV, D-II
    • BA-II, B-I, C-IV, D-III
    • CA-III, B-I, C-II, D-IV
    • DA-III, B-I, C-IV, D-II
    Show answer & solution

    Correct answer: (D) A-III, B-I, C-IV, D-II

    Magnetic moment m = NIA, so its unit is A m2. The magnetic field is in tesla. Current sensitivity is deflection per unit current, phi/I, so rad/A. Magnetization is magnetic moment per unit volume, A m2/m3 = A/m. So the match is A-III, B-I, C-IV, D-II.

Ready to test yourself? Take the 19-question Magnetic Effects of Current, Magnetism, EMI and Alternating Current test →